CIM1007 video signal isolation amplifier
Peripheral circuit: need to input 47uF DC blocking capacitor.
When testing the waveform, a 75Ω load resistor should be connected to the output. Usually the input terminal should also be connected to a 75Ω resistor as the signal source load.
After the output end is connected to the cable, there will be overshoot and oscillation when measuring the square wave response. Connect the 75Ω resistor at the end of the cable and measure again to eliminate the overshoot and oscillation.
The FTTH Installation Accessories Set concludes junction box, fiber wall socket(also named Single family unit rosette, SFU rosette), draw hooks, cable clamp, cable wall bushings, cable glands, cable clips, tail duct, cable wiring duct, nail clip.
Cable drawing hooks are made of metal stainless steel in accordance with ASTM A307.hanging hardware, hard material, with splint type and C type for option. The conduit box, pipe joint box single gang or double gang are made of PC material, fire retardant.
Applications:
Span Clamp is attached to the messenger wire at mid span to hold the p-clamps with drop wires
Telecommunications subscriber loop
Fiber to the home (FTTH)
LAN/WAN
CATV
Drop Wire Hanging Holder,Drop Wire Hanging Holder,Cable Pole Clamp,Cable Fitting Clamp are available.
FTTH Cable Installation Accessories
Drop Wire Hanging Holder,Drop Wire Hanging Holder,Cable Pole Clamp,Cable Fitting Clamp
Sijee Optical Communication Technology Co.,Ltd , https://www.sijee-optical.com